When the pellet machine is in the application of axial pressure and slippage, it will not only harm the production of pellets, but also seriously harm the production of pellets. Therefore, everyone must pay attention to this problem immediately. It can ensure the productivity and manufacturing quality of machinery and equipment, so what is the cause of the slip of the axis of the pellet machine? Below I will give everyone a detailed introduction to the reason and solution of the biomass fuel pellet engine shaft pressure slippage.

1. Insufficient installation of the bearing of the pellet machine can cause the shaft to slip

When installing the rolling bearing of the pellet machine roller, don't install it too hard, otherwise it will cause the pellet machine to have a problem of slipping in the pelletizing work.

The best way to deal with these aspects is to always pay attention to the axial pressure of the roller, even if it is replaced with a new one.

2. Excessive exchange of water in granular raw materials will harm the shaft pressure and slip

When the raw material is suppressed by a pellet machine, the moisture content of the raw material is too large or the steam caused by the pellet machine is too large, which will cause the moisturizing effect of the water when the pellet machine is working. Causes the particle machine shaft pressure to slip.

The best way to deal with these aspects is to reduce the amount of raw material steam input and maintain the flow of water contained in the raw materials within a more effective range.